Geothermal Energy: Wells, Power Plants and Reservoir Cooling

PhysicsPhysics & the EnvironmentAges 15–16Virtual lab

Use with my class

A cross-section of a well drilled into hot rock: the temperature rises with depth by the geothermal gradient G (about 25–30 °C/km in ordinary continental crust, much higher near plate boundaries and hot spots). In Drill a well, set G and the depth, drill and read the temperature at the bottom, and see whether the water is hot enough for a flash steam plant (above 182 °C) or needs a binary-cycle plant. In Produce power, set the extraction rate and the plant efficiency and run 50 years: steam drives the turbine, the cooled water is pumped back, and over-extraction cools the reservoir so the power falls.

Lesson: Geothermal energy; geothermal gradient; geothermal power plants; efficiency; sustainable use and over-extraction

What it shows

Underground, the temperature rises with depth. In ordinary continental crust the geothermal gradient is about 25–30 °C per kilometre, but near plate boundaries and hot spots, where magma lies closer to the surface, it is much steeper. A geothermal power plant brings hot water up a well; above about 182 °C it flashes to steam that spins a turbine, and cooler water runs a binary-cycle plant. The cooled water is pumped back down. If water is taken out faster than the surrounding rock can reheat the reservoir, the reservoir cools and the power falls.

How to use

In Drill a well, set Geothermal gradient G and Well depth, then press Drill: the bit's temperature rises as it goes down, and each well adds a row to the table. In Produce power, set Extraction rate and Plant efficiency η, then press Produce for 50 years and watch the reservoir temperature and the power over the years. Compare a low and a high extraction rate.

Parameters you can change

  • Screen Drill a well, Produce power
  • Geothermal gradient 20–110 °C/km
  • Well depth 0.5–3 km
  • Extraction rate 20–300 kg/s
  • Plant efficiency 5–20 %

Questions to explore

  1. Why is a geothermal well near a plate boundary hotter than one of the same depth in ordinary continental crust?
  2. How does doubling the extraction rate change the reservoir temperature after 50 years?
  3. Why does a geothermal plant's power fall when its reservoir cools?