Semiconductor Devices Lab – MOSFET, Zener Diode, Photodiode and Hall Probe
PhysicsElectricity & CircuitsAges 16–17Virtual lab
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
Four benches with real devices. A 2N7000 MOSFET switches a lamp once the gate voltage passes its threshold; a 1N4733A Zener diode holds the output near 5.1 V as the load changes; a BPW34 photodiode gives a current proportional to illuminance in photoconductive mode and a logarithmic voltage in photovoltaic mode; a Hall probe gives V_H = BI/(nqt), proportional to the magnetic flux density. Each reading records the device's output against its input, with I–V and output graphs.
Lesson: Discrete semiconductor devices: MOSFET switch, Zener voltage regulator, photodiode and Hall-effect sensor
What it shows
Semiconductor devices turn one quantity into another. An n-channel MOSFET conducts only when its gate–source voltage passes a threshold, so a small voltage switches a lamp with almost no gate current. A Zener diode in reverse breakdown keeps its voltage almost constant, so with a series resistor it regulates the voltage across a load. A photodiode gives a current proportional to illuminance when reverse biased and a voltage of its own when unbiased. In a Hall probe the magnetic force pushes charge carriers to one edge until V_H = BI/(nqt), which is why probes are made of semiconductors with a small carrier density.
How to use
Choose a bench on the tabs. MOSFET switch: raise the Gate voltage and watch I_D and the lamp. Zener regulator: change the Input voltage and the Load resistance and watch V_out. Photodiode: pick Photoconductive or Photovoltaic and move the Illuminance. Hall probe: choose the Material and change B, I and t. Press Record reading to add each reading to the table and the graph, then try the tasks.
Parameters you can change
- Bench MOSFET switch, Zener regulator, Photodiode, Hall probe
- Gate–source voltage 0–10 V
- Supply voltage of the MOSFET circuit 5–12 V
- Lamp resistance (MOSFET load) 22–1000 Ω
- Input voltage of the regulator 0–15 V
- Series resistor of the Zener regulator 47–470 Ω
- Load resistance of the regulator 47–4700 Ω
- Load connected to the regulator
- Photodiode mode Photoconductive (reverse bias), Photovoltaic (no bias)
- Illuminance 0–2000 lx
- Resistor in series with the photodiode 1–100 kΩ
- Hall probe material Copper, Indium antimonide (InSb), Sample X (unknown)
- Magnetic flux density -0.5–0.5 T
- Current through the probe 1–100 mA
- Probe thickness 0.05–1 mm
Questions to explore
- Why does a lamp switched by a MOSFET stay off until the gate voltage passes a certain value?
- Why does the Zener current fall when the load takes more current, while the output voltage hardly changes?
- Why is the Hall voltage of a semiconductor probe far larger than that of a copper strip?