Liquid pressure – tank and pressure gauge

Integrated ScienceForces & MotionAges 13–14Virtual lab

Use with my class

Drag a pressure gauge to different depths in a tank and read p = p₀ + ρgh. In the square pool, change the liquid and the gravity and switch the atmosphere on or off; in the chamber pool with wide and narrow sections, see that pressure depends only on depth, not on the shape of the container; in the mystery pool, measure the pressure and work out the density of an unknown liquid. The Atmosphere screen carries a barometer from sea level up a mountain or in a plane to show atmospheric pressure falling with altitude (to half at about 5.5 km), shows Torricelli's 760 mm mercury column, reads a U-tube manometer (absolute and gauge pressure), and explains the crushed can and the Magdeburg hemispheres with the particle model. Adapted from the "Under Pressure" simulation by PhET Interactive Simulations, University of Colorado Boulder (CC BY 4.0); rewritten.

Lesson: Pressure in liquids, atmospheric pressure

What it shows

Pressure in a liquid grows with depth because the weight of the liquid above presses down: p = p₀ + ρgh, where p₀ is the atmospheric pressure at the surface, ρ the density and g the gravitational field strength. It depends only on depth, density and g, not on the shape or width of the container, so connected sections show equal pressures at equal depths. Air is a fluid too: atmospheric pressure is the weight of the air column above each square metre, about 101 kPa at sea level, and it falls roughly exponentially with altitude, to about half at 5.5 km.

How to use

In Square pool, drag the gauge, change the liquid, gravity and atmosphere, and press Add gauge to compare two depths. In Chamber pool, measure at the same depth in different sections. In Mystery pool, work out the density, choose The liquid is… and press Check. In Atmosphere, pick an experiment: drag the barometer up and press Record reading, tilt the Torricelli tube, open the gas tap of the U-tube manometer, press Heat then Turn over into cold water, or pump the air out of the hemispheres.

Parameters you can change

  • Screen Square pool, Chamber pool, Mystery pool, Atmosphere
  • Liquid (Square pool, Chamber pool) Water (1000 kg/m³), Gasoline (700 kg/m³), Honey (1420 kg/m³), Custom
  • Gravity (Square pool, Chamber pool) Earth (9.8 m/s²), Moon (1.6 m/s²), Jupiter (24.8 m/s²), Custom
  • Atmosphere on (Square pool, Chamber pool)
  • Show reference density table (Mystery pool)
  • Experiment (Atmosphere) Going up, Torricelli tube, U-tube manometer, Crushed can, Magdeburg hemispheres
  • Altitude (Atmosphere) 0–12000 m

Questions to explore

  1. Why does the gauge read the same pressure at equal depths in the narrow and the wide section?
  2. Why is the mercury column of a barometer shorter on a high mountain than at sea level?
  3. If the gauge reads 121 kPa at a depth of 2 m on Earth, what is the density of the liquid?